Email #10
Frame Curves!!!
Make your friends ask "how'd he do that??!" when they see the perfectly smooth bends you've got in your rectangular tube frame rails. Without expensive special machinery, a sweeping 3" x 2" frame rail was almost impossible until now - our four piece frame curve kits let you feel great about doing the work yourself! Because the top and bottom plates are scribed at 30°, 45°, and 60°, you can consistently replicate driver and passenger rails. Click on the picture above to learn more...

These lines are just scribed in the top and bottom plates to show 30, 45, and 60 degrees.

You can see how the tabs hold the pieces at a perfect corner-to-corner position.

Here is an example of the ground radius.

This is how you receive the pieces.
Just like Paul Simon said...
There are Fifty Ways to Mount a Brake Pedal Pad
I'll show you two...
1. Weld # 21252-A threaded bung to the end of the pedal , and thread your pedal pad right to it (as long as it has 1/2-20 threads).
2. Here is our #12920 brake pedal pad bracket. All you do is drill two holes in the end of the pedal, and bolt on these stainless brackets. You can slide the pedal pad up and down in the slot to adjust your pedal ratio, and also adjust the angle the pad will sit at when you drill the holes.
Where do you buy your parts?
Would you like to be able to pick up some smart looking brackets off the shelf? Just print this little paragraph and recite it to your local parts guy:

"Hi. I'm _______ (say your name (if said parts guy knows your name, move on to sentence #2)) . Man, have you seen those sweet brackets and tabs and stuff that Welder Series has? It would be swell if I could walk in here and get a bracket when I need one instead of having to wait for __________ (your UPS drivers name, because you should know it by now) to bring it. Well, I guess that's all for now... bye."
And remember...
Top
 
copyright © www.welderseries.com