As I’m reassembling the car, there are some things that I think I should have explained a little better at the time of the first article. The emergency brake handle mount is a neat little piece, but I don’t think I explained how it attaches to the floor.
See that little bung at the button end of the ‘canoe’? The bottom of that bung sits on the top surface of the bottom floor panel. Get that? I think you will. I used the Lokar ratchet mechanism and incorporated it into the canoe, which drops the handle into the floor.
The canoe was made from the outside section of a bent 1-5/8″ tube.
This is the hole where the canoe sits.
Below the 2″ thick floor, the linkage fits through a slot in the bottom floor panel. I bent up a linkage rod required to clear the center section tube and threaded it on both ends.
I drilled and tapped the Lokar brass block so it would work with my threaded linkage rod.
I used a 3/8″ heim joint (or “rod end”) to support the linkage rod and also to serve double duty as the upper bolt for the transmission mount.
A little out of place, but an update nonetheless. I put heat shrink on the wires as they exit from the frame rail and tuck in to the grille shell so they won’t stand out like… wires.
Comments