Rear Shock Mount, Lower

Designed as a lower shock mount for the rear end. Heavy-duty 3/16" formed steel for greater strength.

$20.00

Use Welder Series #21854 block (see related products below) and this bracket becomes a lower coil-over or ShockWave mount. (Or see Welder Series #223501-2 for the kit.) The 3 holes are 5/8″ diameter on 1″ centers. The lowest hole is 4-1/2″ below the bottom of the axle tube. Made to fit 3″ diameter axle tubes.

Priced individually.

Products related to "Rear Shock Mount, Lower"

- Axle Bracket (Batwings) Kit
  
  from $57.00
  
  For four link front suspension. The c-plate is designed to mount the side plates vertically even though the axle boss is on an angle.
- Axle Bracket - Rear, Parallel
  
  from $21.00
- Axle Bracket - Rear, Triangulated
  
  from $22.00
  
  Designed for the triangulated rear 4-link kit to mount the coil-over and the lower bar
- Axle Bracket Kit - Combination Air Spring/ 4-Link
  
  from $87.20
  
  Mount your air springs on the same bracket as your parallel four link bars.
- Axle Bracket Kit - Parallel Four Link
  
  from $70.00
  
  Combination rear axle bracket/ lower coilover mount.
- Axle Bracket Kit, for Coil-Overs
  
  from $64.00
  
  Heavy-duty 3/16" formed steel, available with or without a coil-over bolt kit.
- Axle Bracket Side Plate
  
  $10.00
  
  This axle bracket allows the coilover to be mounted lower relative to the axle. #27801
- Coil-Over Support Block
  
  $14.00
  
  3" x 1" x 1" with 3 holes, 5/8" dia on 1" centers.
- Plate, for Bolt-On Shock Mount
  
  $7.25
  
  3-½" x 2-3/8" with 4 holes 5/16" diameter. Designed to turn #1030 into a bolt-on mount. #10305