Hardware

Hardware

Views:

- Tubing End Cap
  
  $2.00
  
  The slightly dished shape gives a clean, finished look to the end of a 1-5/8" or 1-3/4" round tube.
- Bolt, 5/8-18 x 12"
  
  $5.00
  
  Great for lower control arms. Grade 5, zinc plated.
- Bolt: 1/2-20 Thread, Choose Length
  
  from $0.90
  
  Grade 5, zinc plated. Used in our four link kits, motor mounts, etc. Available in lengths from 2" to 5", measured from under the head to the end of the threads.
- Bolt: 3/8-16 Thread, Choose Length
  
  from $0.20
  
  Grade 5, zinc plated. Available in lengths from 3/4" to 5".
- Coil Over Wrench
  
  $7.75
  
  Designed for notched threaded spring collars. Can also be used with collars that have a hole in them by rounding off the tip.
- Nut, 11/16-18 RH & LH
  
  from $4.15
  
  Nut for Ford tie rod ends.
- Nut, 3/4-16 LH & RH
  
  from $1.00
- Nut, 3/8-24 LH & RH
  
  $0.15
  
  3/8-24 jam nuts available in right and left hand threads.
- Nut, 9/16-18
  
  $0.25
  
  Jam nut for Mustang II rack tie rod ends. Not plated.
- Nutserts
  
  $0.50
  
  Available in 3/8-16 and 5/16-18, great for adding threads to finished surfaces, especially sheet metal up to 1/8".
- Rod Ends, 3/8-24, RH & LH
  
  from $13.00
  
  3/8-24 thread, available LH and RH and with or without Teflon lining.
- Strut Rod Washer
  
  $0.50
  
  2-¼" OD x 1-½" ID x 1/8" thick.
- U Bolt, ½-20 thread
  
  $2.35
  
  2-½" ID, 3-½" legs. Use with #15702 clamp plate. Does not fit stock Ford clamp plates.
- Washer, Dished Stainless
  
  $0.30
  
  1-3/8" O.D. Use with Total Cost Involved, Deuce Factory, or other urethane bushings that have a curved outer surface. Available for 1/2", 9/16", and 5/8" bolts.
- Weld Nuts
  
  from $5.00
  
  Available in 1/4-20, 5/16-18, 3/8-16, and 1/2-13 threads.