Dear Welder Series: parts for 1971 Mustang?

Dear Welder Series…

I am restoring a 1971 mustang coupe. I would like to add a 4-link rear suspension and a coil over front suspension.

Could you make some recommendations on which products I would need to purchase from you.  This will be a

weekend driver with a stock 351w, a 9 inch rear end and T5 transmission.  Thanks.

Dear Danny…
This will be a great cruiser, Danny.  Use our 60″ Mustang II kit, http://104.154.121.234/online-store/ws14540/ or http://104.154.121.234/online-store/mustang-ii-crossmember-for-coil-springs-copy/ .

Engine mounts could be http://104.154.121.234/online-store/ford-motor-mounts-rubber-insulated/ or http://104.154.121.234/online-store/ford-motor-mounts-urethane-insulated/ .

For a Pro/Street rear 4-link kit go to http://104.154.121.234/online-store/four-link-kit-prostreet/ .  A diagonal link will be necessary for this set-up.  We can fix you up with this after the 4-link is installed.  Some specific dimensions are required to make the bar the right length.

For a parallel 4-link go to http://104.154.121.234/online-store/rear-four-link-kit-parallel-universal/ .  A Panhard kit is necessary to keep the frame centered above the rear end.  Check them at http://104.154.121.234/online-store/panhard-kit-universal-rear/ and http://104.154.121.234/online-store/panhard-kit-8-or-9-ford-rear-end/ .

We have a triangulated rear 4-link, too.  It’s at http://104.154.121.234/online-store/rear-four-link-kit-triangulated/ .

Thanks for looking at Welder Series parts.

Paul Horton

Leave a Reply